SHC Policy Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
=====Sandbox Page=====
<WRAP center round box 68%>
**Preamble**

Evergreen Co-op was established for the purpose of teaching, learning and living in cooperation with each other and the community. We are guided by these cooperative principles:

  - **1.** Membership is open to all, without social, political, gender, ethnic, or sexual orientation discrimination.

  - **2.** Democratic decision making, one person = one vote. 

  - **3.** Limited interest, if any, on capital placed with the house. 

  - **4.** Savings distributed equally, or placed for the further development of the house. 

  - **5.** Constant education of members in co-op principles and methods.

  - **6.** Cooperation with other cooperatives.

  - **7.** Concern for community.
</WRAP>

^ This ^ is ^ a ^ table ^
| This column is wider || than | others! |
| this | is | my | first |
| DokuWiki | edit, | so | please |
| **be nice!** ||||

====== Deploy ======

=== Hardware ===

FreeNAS can be installed on almost any hardware but to best suit the requirements of B-C-D it must meet the following:

  * An Intel atom or higher with ECC compatability.
  * 8+ GB of ECC RAM (speed is not important as long as it is compatible with the motherboard. ECC is important).
  * Flash based storage for the OS. SSD is recomended for reliability but a USB flash drive is completely acceptable.

=== Steps to connect to Active Directory ===

  - 1.Select **Directory Service > Active Directory**.
  - 2. Enter the DNS name of the domain (exaple.com instead of just example) in the **Domain Name** section. Enter the user name and password in the proceeding sections to authenticate to the domain (use an account that has permission to bind to the network).
  - 3. Click **Advanced Mode**.
  - 4. Add the main Domain Controller under the **Domain Controller** section (winserver1).
  - 5. Last check to ensure **Lsmap backend** is **rid** then select **Save**.
  - 6. The FreeNAS server now binds to the domain (which may take 5 to 15 minutes).
  - 7. To confirm the bind was successful open a command prompt and run wbinfo -u and you should get a list of all users on the domain.
  - 8. If there are issues read the official FreeNAS documentation on binding to a domain.

=== Steps to Deploy a Samba share ===

  - 1. Connect to FreeNAS.
  - 2. If needed create a new volume.
  - 3. Set the permissions on the new volume by selecting the volume then **Change Permissions**.
  - 4. Using the two **Owner** drop downs, select the appropriate user and group owners.
  - 5. Next select **Windows** in the **Permission Type:** section.
  - 6. Finally select **Set permission recursively:** then click **Change**.
  - 7. Next select **Sharing > Windows (SMB) Shares > Add Windows (SMB) Share**.
  - 8. Select the volume you created under **Path:** then add the name it will be accessed by under **Name:**.
  - 9. Leave the rest at the default and click **OK**.
  - 10. By creating the share Samba will be activated as well.